Service Intervals
Servicing Your Machine
IMPORTANT: Avoid damage! Operating in extreme conditions may require more frequent service intervals:
· Engine components may become dirty or plugged when operating in extreme heat, dust or other severe conditions.
· Engine oil may lose efficiency if vehicle is operated constantly at slow or low engine speeds or with frequent short trips.
|
Please use the following timetables to perform routine maintenance on your machine.
As Needed
· Replace alternator belt.
· Replace air filter elements (see air restriction indicator).
· Replace light bulbs.
· Lubricate seat slide rails.
· Replace fuses.
· Clean and replace battery.
· Replace radiator hoses and clamps.
· Check tire air pressure.
· Clean fuel tank overfill reservoir.
· Drain water and sediment from fuel tank.
· Check and adjust front wheel toe-in.
· Check and clean grille and side screens.
· Check and clean radiator cooling screen.
· Clean debris from engine compartment.
Break-in - After 10 Hours
· Check wheel bolt torque.
Break-in - After 50 Hours
· Change engine oil and filter.
· Check wheel bolt torque.
Every 10 Hours or Daily
· Test safety systems.
· Check engine oil level.
· Check transmission oil level.
· Check air filter rubber dust unloading valve.
· Check radiator coolant level.
Every 50 Hours
· Check front axle oil level.
· Lubricate machine.
Every 200 Hours
· Check engine oil and filter.
· Inspect alternator belt.
· Check air restriction indicator light.
· Check wheel bolt torque.
Every 400 Hours
· Change transmission oil and filter.
· Clean transmission suction screen.
· Replace fuel filter.
· Remove air filter and inspect elements.
Every 600 Hours
· Check engine high and low idle speeds.
· Check air filter intake hoses and clamps.
· Change front axle oil.
· Check front axle thrust bolt torque.
· Check brake adjustment.
Yearly
· Check radiator coolant freeze point and clarity.
· Drain water from fuel tank and replace fuel filter.
· Check all hoses and clamps.
· Change engine oil and filter.
Every 1200 Hours
· Check and clean inline hydraulic filter.
Every Two Years or 2000 Hours
· Flush and replace factory coolant. Flush cooling system and replace coolant with John Deere COOL-GARD engine coolant.
|