Specifications

Engine

Manufacturer Yanmar

Model Number 3TNV84

Type Diesel

Gross Horsepower 23.9 kW (32.1 hp)

Manufacturer’s Estimated PTO Horsepower 17.9 kW (24 hp)

Low Idle Speed 950 rpm

Rated Engine Speed 2800 rpm

High Idle Speed 2975 rpm

Operating Range 950 - 2975 rpm

Engine Torque @ Rated Speed 75.4 N•m (55.6 lb-ft)

Maximum Torque @ 1680 rpm 100 N•m (73.8 lb-ft)

Displacement 1.5 L (91.5 cu in.)

Cylinders 3

Bore and Stroke 84 x 90 mm (3.3 x 3.54 in.)

Compression Ratio 19:1

Lubrication Pressurized

Cooling System Water Pump

Oil Filter Single Element

Air Cleaner Dry Type with Safety Element

Starting Aid Air Heater

Electrical System

Type 12 Volt

Battery Capacity 500 Cold Cranking Amps at -18?C (0?F)

Battery Size 22NF

Alternator 75 Amp

Starter Size 1.2 kW (1.6 hp)

Fuel System

Fuel Filter Replaceable Element

Fuel Diesel

Fuel Pump In-Line with Electric Shutoff

Fuel Delivery Direct Injection, Self Bleeding

Drive Train

Transmission 2 Range Hydrostatic

Number Of Speeds Infinite Forward, Infinite Reverse

Mechanical Front Wheel Drive Standard

Capability for MFWD All Ranges

Rear Final Drive Type Spur Gear

Differential Lock Mechanical

Brakes Type Wet Disk

Steering Power, Hydrostatic

Front Axle Operating Capacity 1450 kg (3197 lb)

Rear Axle Operating Capacity 1815 kg (4002 lb)

Drawbar Tongue Capacity 400 kg (882 lb)

Hydraulic System

Type of System Open Center

Power Steering Standard

Implement and Steering Pump Type Dual Tandem Gear Pump

Working Pressure 14651 kPa (2150 psi)

Steering Pressure 10342 kPa (1500 psi)

Pump Capacity (Main) @ Rated Speed 28.8 L/min (7.6 gpm)

Pump Capacity (Power Steering) @ Rated Speed 21.6 L/min (5.7 gpm)

Total Flow of Pumps @ Rated Speed 50.4 L/min (13.3 gpm)

3 Point Hitch

Type Category 1

Lift Capacity (24-in. behind link arms) 849 kg (1868 lb)

Dimension - Lower Link Ball Socket ID 22 mm (7/8 in.)

Dimension - Upper Link Pin Hole ID 19 mm (3/4 in.)

Dimension - Normal Width @ Lower Hitch Pins 68.6 cm (27 in.)

Dimension - Normal Height From Center Pin to Hitch Pin 45.7 cm (18 in.)

PTO

Type Independent

Clutch Type Wet Disk

Brake Type Wet Disk

Speed (Rear PTO rpm @ Rated Engine Speed) 540 rpm

Fluid Capacities

Fuel Tank 43.5 L (11.5 gal)

Cooling System 5.3 L (1.4 gal)

Crankcase w/ Filter 4.3 L (4.5 qt)

Transmission and Hydraulic System 25.7 L (6.8 gal)

Front Axle 4.5 L (1.2 gal)

Ground Speeds

Note: All ground speeds shown are with machine equipped with standard tires and operated at 2800 engine RPM.

Forward (Low Range) 9.4 km/h (5.8 mph)

Forward (High Range) 20.8 km/h (12.9 mph)

Reverse (Low Range) 9.1 km/h (5.6 mph)

Reverse (High Range) 20.2 km/h (12.5 mph)

Tires

Front 15.0-19.5 4PR R4

Rear 25x8.50-14 4PR R4

Tire Inflation Pressures

NOTE: Minimum / Maximum pressures given. Minimum pressure is for unloaded, unballasted tractor.

Front (15.0-19.5 4PR R4) 138 kPa/210 kPa (20 psi/31 psi)

Rear (25x8.50-14 4PR R4) 83 kPa/340 kPa (12 psi/39 psi)

Tire Loads

NOTE: Maximum load capacity for single tire.

Front (15.0-19.5 4PR R4) 620 kg (1367 lb)

Rear (25x8.50-14 4PR R4) 1790 kg (3946 lb)

Dimensions

Wheelbase 1,73 m (68 in.)

Overall Length w/ 3-Point Hitch 3,05 m (120.2 in.)

Overall Width (minimum) 1,35 m (53.1 in.)

Overall Width (maximum) 1,76 m (69.1 in.)

Height From Ground

To Top of Hood 1,39 m (54.7 in.)

To Top of ROPS 2,10 m (83 in.)

Weight

With ROPS, 3-Point Hitch and all fluids 1225 kg (2700 lb)

Recommended Lubricants

Engine Oil John Deere Plus-50 or TORQ-GARD SUPREME (See SERVICE ENGINE for more information.)

Grease John Deere Multi-Purpose SD Polyurea Grease

John Deere Multi-Purpose HD Lithium Complex Grease

Transmission Oil Low Viscosity HY-GARD (JDM J20D)

Front Axle Oil Low Viscosity HY-GARD (JDM J20D)

(Specifications and design subject to change without notice.)

Torque Values

Metric Hardware

Inch Fastener Hardware