All Manuals Close Window

Safety Labels


Understanding The Machine Safety Labels

The machine safety labels shown in this section are placed in important areas on your machine to draw attention to potential safety hazards.

On your machine safety labels, the words DANGER, WARNING, and CAUTION are used with this safety-alert symbol. DANGER identifies the most serious hazards.

The operator’s manual also explains any potential safety hazards whenever necessary in special safety messages that are identified with the word, CAUTION, and the safety-alert symbol.

DANGER


T146195

Picture Note: Located on starter on left side of engine.

Start only from seat in park or neutral.

Starting in gear kills.

DANGER POISON


M88249

Picture Note: Located on battery.

SHIELD EYES: EXPLOSIVE GASES CAN CAUSE BLINDNESS OR INJURY.

NO SPARKS, FLAMES, SMOKING.

SULFURIC ACID CAN CAUSE BLINDNESS OR SEVERE BURNS.

FLUSH EYES IMMEDIATELY WITH WATER. GET MEDICAL HELP FAST.

KEEP OUT OF THE REACH OF CHILDREN. DO NOT TIP. KEEP VENT CAPS TIGHT AND LEVEL.

WARNING AVOID CRUSHING


LVU10709

Picture Note: Located on inside of right fender on tractor without cab.

• Keep Rollover Protective Structure fully extended.

• Do not jump if machine tips.

• Use seat belt.

When structure must be down;

• DO NOT use seat belt.

• Drive with extra care.

WARNING ROPS


R141735

Picture Note: Located on inside of right side of ROPS on tractor without cab.

If a canopy or sunshade is attached to the ROPS structure, the weight MUST be limited to 100 lb (45 kg) or less.

WARNING ROPS


R120124

Picture Note: Located on inside left cab frame on cab tractor.

To maintain unimpaired operator protection and manufacturer’s ROPS certification:

• Damaged ROPS structures must be replaced, not repaired or revised.

• Any alteration to the ROPS must be approved by the manufacturer.

WARNING


M117557

AVOID INJURY FROM PTO .

• Keep all shields in place.

• Keep hands, feet and clothing away.

• Operate only with 540 RPM.

WARNING


M117554

Hot surface

CAUTION HOT SURFACE



Picture Note: Located on muffler.

NOTE: No-text warning molded into muffler.

Do not touch engine muffler, it may be hot.

CAUTION READ OPERATORS MANUAL


LVU10708

1. Read Operator’s Manual before operating this machine.

2. Keep all shields in place.

3. Hitch towed loads only to drawbar to avoid rearward upset.

4. Make certain everyone is clear of machine before starting engine or operation.

5. Keep all riders off machine and equipment.

6. Keep hands, feet and clothing away from power-driven parts.

7. Reduce speed when turning or applying individual brakes or operating around hazards on rough ground or steep slopes.

8. Couple brake pedals together for road travel.

9. Use flashing warning lights on highway unless prohibited by law.

10. Stop engine, lower implement to ground and shift to “PARK” or set brake(s) securely before dismounting.

11. Wait for all movement to stop before servicing machinery.

12. Remove key if leaving machine unattended.

CAUTION READ OPERATORS MANUAL


MIU10747

Picture Note: Located on inside right cab frame on cab tractor.

1. Read the operator’s manual before operating the tractor.

2. Keep all shields in place.

3. Hitch towed loads only to drawbar to avoid rearward upset.

4. Make sure everyone is clear of machine before starting engine or operation.

5. Keep all riders off tractor and equipment.

6. Keep hands, feet, and clothing away from power-driven components.

7. Reduce speed when turning or applying individual brakes or operating around hazards on rough ground or steep slopes.

8. Couple brake pedals together for road travel.

9. Use flashing warning lights on highway unless prohibited by law.

10. Stop engine lower implement to ground and shift to “PARK” or set brake(s) securely before dismounting.

11. Wait for all movement to stop before servicing machinery.

12. Remove key if leaving tractor unattended.

CAUTION iMatch™ Quick-Hitch


LVU13502

Picture Note: Optional iMatch Quick-Hitch.

BEFORE USING, SECURE TRACTOR IMPLEMENT WITH BOTH LOCKING LUGS OVER LOWER IMPLEMENT PINS

Emission Control System Certification Label



c CAUTION: Avoid injury! Statutes providing severe penalties for tampering with emissions controls may apply at the user’s location.

The emissions warranty described in the warranty section applies only to those engines marketed by John Deere that have been certified by the United States Environmental Protection Agency (EPA) and/or California Air Resources Board (CARB); and used in the United States in non-road mobile (self-propelled or portable/transportable1) equipment. The presence of an emissions label like the one shown signifies that the engine has been certified with the EPA and/or CARB. The EPA and CARB warranties only apply to new engines having the certification label affixed to the engine and sold as stated above in the geographic areas governed by the regulating agencies.

NOTE: The hp/kW rating on the engine emissions certification label specifies the gross engine hp/kW, which is flywheel power without fan. In most applications this will not be the same rating as the advertised vehicle hp/kW rating.

1

Equipment moved at least once every 12 months.