Safety Labels
Safety Label Location
Picture Note: Use label number listed in table below to locate complete text of safety label message following this illustration.
Picture Note: Use label number listed in table below to locate complete text of safety label message following this illustration.
Understanding The Machine Safety Labels
The machine safety labels shown in this section are placed in important areas on your machine to draw attention to potential safety hazards.
On your machine safety labels, the words DANGER, WARNING, and CAUTION are used with this safety-alert symbol. DANGER identifies the most serious hazards.
The operator’s manual also explains any potential safety hazards whenever necessary in special safety messages that are identified with the word, CAUTION, and the safety-alert symbol.
WARNING ROPS R141735
If a canopy or sunshade is attached to the ROPS structure, the weight MUST be limited to 100 lb (45 kg) or less.
WARNING M117557
AVOID INJURY FROM PTO .
• Keep hands, feet and clothing away.
DANGER T146195
Start only from seat in park or neutral.
CAUTION READ OPERATORS MANUAL LVU10708
1. Read Operator’s Manual before operating this machine.
3. Hitch towed loads only to drawbar to avoid rearward upset.
4. Make certain everyone is clear of machine before starting engine or operation.
5. Keep all riders off machine and equipment.
6. Keep hands, feet and clothing away from power-driven parts.
7. Reduce speed when turning or applying individual brakes or operating around hazards on rough ground or steep slopes.
8. Couple brake pedals together for road travel.
9. Use flashing warning lights on highway unless prohibited by law.
10. Stop engine, lower implement to ground and shift to “PARK” or set brake(s) securely before dismounting.
11. Wait for all movement to stop before servicing machinery.
12. Remove key if leaving machine unattended.
WARNING AVOID CRUSHING LVU10709
• Keep Rollover Protective Structure fully extended.
• Do not jump if machine tips.
WARNING M117554
WARNING ROPS R120124
To maintain unimpaired operator protection and manufacturer’s ROPS certification:
• Damaged ROPS structures must be replaced, not repaired or revised.
• Any alteration to the ROPS must be approved by the manufacturer.
WARNING LVU22753
AVOID AMPUTATION
• Hands or fingers may be pinched between folded ROPS and rear implements. Do not place hands or fingers near foldable ROPS when implements are raised.
CAUTION READ OPERATORS MANUAL MIU10747
1. Read the operator’s manual before operating the tractor.
3. Hitch towed loads only to drawbar to avoid rearward upset.
4. Make sure everyone is clear of machine before starting engine or operation.
5. Keep all riders off tractor and equipment.
6. Keep hands, feet, and clothing away from power-driven components.
7. Reduce speed when turning or applying individual brakes or operating around hazards on rough ground or steep slopes.
8. Couple brake pedals together for road travel.
9. Use flashing warning lights on highway unless prohibited by law.
10. Stop engine lower implement to ground and shift to “PARK” or set brake(s) securely before dismounting.
11. Wait for all movement to stop before servicing machinery.
12. Remove key if leaving tractor unattended.
WARNING LVU10707
AVOID CRUSHING. Do not jump if machine tips.
CAUTION LVU22771
Picture Note: Optional iMatch quick-attach hitch.
BEFORE USING, SECURE TRACTOR IMPLEMENT WITH BOTH LOCKING LUGS OVER LOWER IMPLEMENT PINS
