Safety Labels
Understanding The Machine Safety Labels
The machine safety labels shown in this section are placed in important areas on your machine to draw attention to potential safety hazards.
On your machine safety labels, the words DANGER, WARNING, and CAUTION are used with this safety-alert symbol. DANGER identifies the most serious hazards.
The operator's manual also explains any potential safety hazards whenever necessary in special safety messages that are identified with the word, CAUTION, and the safety-alert symbol.
WARNING: AVOID SERIOUS INJURY OR DEATH
· Drive up and down slopes, not across.
· If machine stops going uphill, stop blade and back down slowly.
· Keep safety devices (guards, shields, and switches) in place and working.
· When leaving machine: Stop engine, Set park brake, Remove key.
DANGER: ROTATING BLADES CUT OFF ARMS AND LEGS
· Do not mow when children or others are around.
· Look down and behind before and while backing.
· Never carry children even with the blades off.
WARNING : LOADED SPRING (For Lift Assist)
Picture Note: Label is located on both sides of deck when (optional) lift assist is installed; lift assist is standard on LT180
· To avoid injury from loaded spring, read Operator's Manual before changing attachment.
DANGER: SHIELD EYES-EXPLOSIVE GASES CAN CAUSE BLINDNESS OR INJURY
Picture Note: Label is located on battery
· Sulfuric acid can cause blindness or severe burns.
CAUTION: Flush Eyes Immediately With Water
· Keep out of reach of children.
· Keep vent caps tight and level.
DANGER: ROTATING BLADE
Picture Note: 48-Inch deck used for illustration. Decals are located on both sides of Freedom42 deck and left side of all other decks
· Do not put hands or feet under or into mower when engine is running.
DANGER: ROTATING BLADE
Picture Note: Labels are located on discharge chute and right-hand side of 48-inch deck
· Do not put hands or feet under or into mower when engine is running.
Thrown Objects
· Before mowing, clear area of objects that may be thrown by blade.
· Do not operate mower without discharge chute or entire grass catcher in place.
Emission Control System Certification Label
NOTE: Tampering with emission controls and components by unauthorized personnel may result in severe fines or penalties. Emission controls and components can only be adjusted by EPA and/or CARB authorized service centers. Contact your John Deere Commercial and Consumer Equipment Retailer concerning emission controls and component questions.
The presence of an emissions label signifies that the engine has been certified with the United States Environmental Protection Agency (EPA) and/or California Air Resources Board (CARB).
The emissions warranty applies only to those engines marketed by John Deere that have been certified by the EPA and/or CARB; and used in the United States and Canada in off-road mobile equipment.
Emission Compliance Period
If your engine has the emission compliance category listed on the emission control system certification or air index label, this indicates the number of operating hours for which the engine has been certified to meet EPA and/or CARB emission requirements. The following table provides the engine compliance period in hours associated with the category found on the certification label.
Certification
Your mower has been certified by an independent laboratory for compliance with American National Standard B-71.1, "Safety Specifications" for Power Lawn Mowers, Lawn and Garden Tractors, and Lawn Tractors.