
Service Lubrication
Grease
IMPORTANT: Avoid damage! Use recommended John Deere greases to avoid component failure and premature wear.
The recommended John Deere greases are effective within an average air temperature range of -29 to 135 degrees C (-20 to 275 degrees F).
If operating outside that temperature range, contact your Servicing dealer for a special-use grease.
|
The following greases are preferred:
• John Deere Multi-Purpose SD Polyurea Grease
• John Deere Multi-Purpose HD Lithium Complex Grease
If not using any of the preferred greases, be sure to use a general all-purpose grease with an NLGI grade No.2 rating.
Wet or high speed conditions may require use of a special-use grease. Contact your Servicing dealer for information.
Lubricating Rear Steering Pivot (4WS Model)
MX15404
Lubricate joint (A).
MX15405
Lubricate rear wheel pivot (B) on both ends of rear axle.
Lubricating Steering Cylinder Ball Joints
MX15409
Picture Note: 4WS model shown.
Lubricate ball joints (A).
Lubricating Front Axle
MX15406
A - Left King Pin
MX15407
A - Right King Pin
MX15408
A - Axle Center Pivot
Lubricating Machine Grease Fittings (X728)
MX13580, MX13581
A - Left Tie Rod End
B - Right Tie Rod End
C - Front Axle
MX13579
A - Left Steering Cylinder Ball Joint
B - Right Steering Cylinder Ball Joint
MX13583, MX13584, MX13585
A - Four-Wheel Drive Shaft Ends
|