Safety Labels
Safety Label Location
D - ROLL-OVER STRUCTURE DMU211676
E - ROLL-OVER STRUCTURE DMU211677
Understanding The Machine Safety Labels
The machine safety labels shown in this section are placed in important areas on your machine to draw attention to potential safety hazards.
On your machine safety labels, the words DANGER, WARNING, and CAUTION are used with this safety-alert symbol. DANGER identifies the most serious hazards.
The operator’s manual also explains any potential safety hazards whenever necessary in special safety messages that are identified with the word, CAUTION, and the safety-alert symbol.
There can be additional safety information contained on parts and components sourced from suppliers that is not reproduced in this operator’s manual.
DANGER
To avoid injury from rotating blades, stay clear of fan.
WARNING
To avoid injury from tip over, drive across slopes, not up and down. If machine stops going uphill, stop blades and back down slowly.
CAUTION HELP AVOID INJURY
• Keep people a safe distance away
WARNING TCU26800
SPARK ARRESTOR
Operation of This Equipment May Create Sparks That Can Start Fires Around Dry Vegetation. A Spark Arrestor May Be Required. The Operator Should Contact Local Fire Agencies for Laws or Regulations Relating to Fire Prevention Requirements.
WARNING
• Properly tighten stabilizer device after raising ROPS.
WARNING - TCU13514
AVOID CRUSHING
• Keep Rollover Protective Structure fully extended
DANGER - M131748
To avoid injury from rotating blades and thrown objects, stay clear of deck edge and keep others away.
Do not mow without discharge chute or entire grass catcher in place.
DANGER M131739
• To avoid injury from rotating blades, stay clear of deck edge.
DANGER - M137637
• Do not mow without discharge chute or entire grass catcher in place.
WARNING - TCU51051
• To avoid injury from rotating belts, keep all shields and guards in place.
DANGER
• To avoid injury to children, stop mower when children are near. Do not mow in reverse. Look behind when backing. Never carry riders, especially children.
CAUTION TCU27738
• Prolonged exposure to loud noise can cause impairment or loss of hearing.
• Wear suitable hearing protection.
Emission Control System Certification Label
NOTE: Tampering with emission controls and components by unauthorized personnel may result in severe fines or penalties. Emission controls and components can only be adjusted by EPA and/or CARB authorized service centers. Contact your John Deere Commercial and Consumer Equipment Retailer concerning emission controls and component questions.
The presence of an emissions label signifies that the engine has been certified with the United States Environmental Protection Agency (EPA) and/or California Air Resources Board (CARB).
The emissions warranty applies only to those engines marketed by John Deere that have been certified by the EPA and/or CARB; and used in the United States and Canada in off-road mobile equipment.
Emission Compliance Period
If your engine has the emission compliance category listed on the emission control system certification or air index label, this indicates the number of operating hours for which the engine has been certified to meet EPA and/or CARB emission requirements. The following table provides the engine compliance period in hours associated with the category found on the certification label.
Certification
Your product has been certified for compliance with American National Standards Institute B-71.4, Safety Specifications for Commercial Turf care Equipment.