Predelivery

After the machine has been completely assembled, inspect to verify it is in good running order before delivering to the customer. The following checklist is a reminder of points to inspect. Check off each item as it is found satisfactory or after proper adjustment is made.

□ SMV emblem and reflectors installed.

□ Verify all safety decals are in place. (See Safety Signs Location section in this manual for decal locations.)

□ Verify correct speed limit decal is installed for your location.

□ All fluid levels have been checked. All grease fittings have been lubricated.

□ Tires and suspension are properly inflated. Tighten wheel bolts to specified torque.

□ Perform Spreader Check Test with box empty. Manipulate settings to verify that high and low belt speed (manual) and high and low spinner speed are within specifications. (See Spreader Check Test in Spreadstar section of Operator’s Manual.)

□ Verify proper belt tracking and tension. (See Conveyor Belt Maintenance and Adjustment—As Required in Lubrication and Maintenance section of this manual.)

□ Hydraulic systems operate properly and do not leak.

□ Any parts scratched in shipment have been touched up with paint.

□ Factory made entries in Spreadstar monitor have been confirmed and/or reset to agree with calibration values.

□ This machine has been thoroughly checked and to the best of my knowledge is ready for delivery to the customer.

Signed:

Date: