Pre-Operation Checklist

Efficient and safe operation of the machine requires that each operator reads and understands operating procedures and all related safety precautions outlined in this section. A pre-operational checklist is provided for the operator. It is important for both personal safety and maintaining the good mechanical condition of the applicator that this checklist be followed.

Before operating applicator, check the following items:

1. Lubricate machine per schedule outlined in LUBRICATION AND MAINTENANCE section.
2. Use only a tractor of adequate power and weight to operate applicator. See SPECIFICATIONS section for recommendations.
3. Be sure that machine is properly attached to tractor. Be sure that a mechanical retainer is installed through drawbar pin and safety chain is installed.
4. Inspect all hydraulic lines, hoses, fittings and couplers for tightness.
5. Check tires and verify they are inflated to specified pressure.
6. Calibrate applicator if at start of season or a new applicator rate is being used.
7. Check condition and routing of all fluid hoses and lines. Be sure that all lines are routed in large arcs. Replace any that are damaged. Re-route those that are rubbing, pinched or crimped.
8. Check placement components. Remove and replace any that are worn.
9. Remove all entangled material.
10. Raise tool bar and turn metering pump slightly. Check that there is liquid coming out of each nozzle. Unplug or connect lines as required. Replace any nozzles that are plugged.