Specifications

The seed drill system is connected to the following sensors, switches, and actuators:

• 2 hopper reserve gauges (1 gauge for 3 and 4 m drills).
• 1 blower shaft sensor.
• 1 tramline control switch.
• 1 drive wheel sensor.
• 2 meter shaft sensors.
• 2 solenoid shutoff valves.
• 1 full-width shutoff device.
• 1 half-width shutoff device.

The system requires the following to operate correctly:

• 12 volt power supply (no display below 10.5 volt.)
• 16 amp fuse.
• Temperature range: minus 10° C to plus 60° C (14—140° F).

Input data remains stored until canceled.

IMPORTANT: A specified forward speed is required for the display to function correctly.

Item	Measurement	Specification
Forward Speed (Minimum)	Speed	3 km/h (1.9 mph)