Cleaning the Drill

The drill must be cleaned at regular intervals in order to ensure optimum serviceability and performance at all times.

IMPORTANT: Never use a high-pressure cleaner or hose (water jet) to clean the housings of the electronics and blower. The housings, screw connections and ball bearings are not watertight.

Wash the outside of the drill with water. Drain off any water which enters the drill by removing the manifold from the venturi cone.

Clean the cell wheel in the metering device with a narrow brush.

Use compressed air to clean the seed delivery hoses, hopper, metering device and blower.

Take the cover off the chain box and clean the inside.