General

1. IMPORTANT: DO NOT put the selective control valve (SCV) lever in “Float” when raising and lowering machine. Correct procedure for raising and lowering machine is to power completely up or down.

   To prevent plugging of BrushBelt™ or seed openers, lower the machine when moving forward.

   DO NOT back up with machine lowered.

   For proper machine operation, it is important that the machine frame is fully lowered into correct planting position. Achieving this position is difficult with some attachment combinations, especially when planting in hard to penetrate soil conditions. If this situation is encountered, the following action is warranted: Reduce attachment down force levels. Avoid using more attachment down force than required.

   To prevent BrushBelt™ malfunction, do not apply fertilizer directly to the seed furrow in front of the BrushBelt™.

   Use recommended size tractor. See Specifications section.

2. Verify that tractor and machine have been properly prepared. See Prepare Tractor and Prepare Machine sections.

3. Use clean seed for best results.

4. Check seed rates carefully.

5. Check tire pressure before seeding.

6. Before seeding, allow tractor hydraulic oil to warm up thoroughly.