Install Radar Signal Adapter Harness-9000 and 9000T Series TractorNOTE: This harness is used when existing tractor radar will supply signal to monitor and to tractor instrumentation. If tractor is not equipped with radar and a planter radar will be installed, go to "9000 and 9000T Series Tractor-Radar and Bracket Installation". 1. Remove fuse panel cover and locate 2-pin harness (A).
|
|
59082OM,90D -19-27JAN97-1/4 |
|
2. Route signal harness (A) behind console and into fuse panel area.
|
|
59082OM,90D -19-27JAN97-2/4 |
|
3. Connect signal harness to tractor harness. Push connector back to side of fuses. 4. Install fuse panel cover. 5. Route signal harness under floor mat along window. |
|
59082OM,90D -19-27JAN97-3/4 |
|
6. Connect signal harness to monitor radar harness (A).
|
|
59082OM,90D -19-27JAN97-4/4 |