Seed Count Mode

Seed Count Mode allows the operator to view the number of seeds that pass a single row sensor.

AG,OUO1074,840 -19-01MAR00-1/2

To enter this mode Press SCAN and ROW SELECT (A) simultaneously when either the planter is stopped with all rows showing failed, or during normal planting when all rows are not failed.

The ROW ON/OFF switch (B) alternately STARTS and STOPS the count. The 0-9 switch (C) resets the accumulated count and increments the row number selected.

To exit this mode push either SCAN, ROW SELECT, AREA/SPEED, POP SPACING or SETUP SELECT switches. While in this mode row failures will be displayed but HI-LO warnings will not. Also the DIST/FAILED function is inoperative in this mode. If a ROW FAILURE occurs, the SEED COUNT MODE will be exited.

A-SCAN and ROW SELECT
B-ROW ON/OFF Switch
C-0-9 Switch

AG,OUO1074,840 -19-01MAR00-2/2