Regular, Regular Straight, Small Straight and Large Seed Tubes (MaxEmerge Plus Row Units)

If seed tubes must be removed or replaced, proceed as follows:

To remove:

1. Disconnect planter harness from seed tube sensor.

AG,OUO1074,847 -19-01MAR00-1/5

2. Remove shank cover (A).


A-Cover

A41218

AG,OUO1074,847 -19-01MAR00-2/5

3. Depress front of seed tube to disengage tabs (A) from latching holes (B).

4. Remove seed tube.

To install:


A-Disengage Tabs
B-Latching Holes

A39958

AG,OUO1074,847 -19-01MAR00-3/5

IMPORTANT: If seed tube is not properly located on aligning pin, inaccurate seed metering and/or damage to the seed tube may occur.

1. Position seed tube in shank, making certain it is engaged on pin (A).

2. Depress front of seed tube and engage tabs (B) in latching holes.


A-Pin
B-Engage Tabs

A41217
A41219

AG,OUO1074,847 -19-01MAR00-4/5

3. Route harness lead (A) out of shank as shown.

4. Replace shank cover (B).

NOTE: make certain all slack is out of sensor lead before securing with ties.

5. Connect seed tube sensor harness to planter harness.


A-Harness Lead
B-Cover

A41220

AG,OUO1074,847 -19-01MAR00-5/5