30-55 Series Utility Tractor-Radar and Bracket Installation

1. Install two 5/8 x 1-1/2 in. cap screws (A) in right-hand engine rail.

2. Install radar mounting bracket on cap screws with lock washers and nuts as illustrated.

A-Cap Screws

AG,OUO1074,852 -19-01MAR00-1/2

CAUTION: Avoid looking directly into the sensor face of radar to prevent possible eye damage from microwave signal emitted from radar sensor.

NOTE: Be certain radar unit is mounted to bracket with serial number plate facing up.

3. Attach radar unit (A) to inside of mounting bracket with four 1/4 x 4 in. cap screws (B), flat washers and lock nuts. (washers under head of cap screws against radar unit).

4. Route radar cable toward rear axle and connect to power module lead.

A-Radar Unit
B-Cap Screws

AG,OUO1074,852 -19-01MAR00-2/2