30-60 Series Row Crop Tractors (with Cab)-Console Installation

NOTE: For open station tractors see 30-60 Series Open Station Tractors Console Installation, this group.

1. Assemble monitor brackets (A) together and attach to window ledge with cap screws (B).

2. Place rubber washer (C) over hole.

3. Attach monitor to bracket.

4. Install monitor harness and radar harness into grommet.

A-Brackets
B-Cap Screws
C-Rubber Washer

AG,OUO1074,853 -19-01MAR00-1/8

5. Install grommets (A) into rear plate (B) as illustrated.

6. Attach plate to cab with six 5/16 x 7/8 in. screws (C).

A-Grommets
B-Rear Plate
C-Screws

AG,OUO1074,853 -19-01MAR00-2/8

NOTE: If tractor is equipped with a 2-pin convenience outlet, order AA37254 to convert 2-pin to a 3-pin outlet.

If tractor is not equipped with a convenience outlet, order AA37247.

7. Carefully push monitor power connector (A) into convenience outlet (B) and turn collar clockwise.

A-Monitor Power Connector
B-Convenience Outlet

AG,OUO1074,853 -19-01MAR00-3/8

8. Remove four cap screws (A), two nuts and SAVE for reuse.

9. Remove connector mounting plate (B) and DISCARD.

A-Cap Screws
B-Mounting Plate

AG,OUO1074,853 -19-01MAR00-4/8

10. Install harness connector (A) through slot in bracket (B).

11. Mount bracket (B) (legs to front) to tractor SCV with two cap screws (C) previously removed.

12. Install two cap screws (D) and nuts previously removed through connector (A) to bracket (B).

A-Harness Connector
B-Bracket
C-Cap Screws
D-Cap Screws

AG,OUO1074,853 -19-01MAR00-5/8

13. Install socket (A) to connector bracket (B) with two M8 x 16 cap screws and M8 nuts.

A-Socket
B-Connector Bracket

AG,OUO1074,853 -19-01MAR00-6/8

14. Attach monitor harness connector (A) to mounting spade (B) using four self-tapping screws (C) provided with monitor.

A-Harness Connector
B-Mounting Spade
C-Self-tapping Screws

AG,OUO1074,853 -19-01MAR00-7/8

15. Insert monitor spade into socket.

AG,OUO1074,853 -19-01MAR00-8/8