30-50 Series Four-Wheel Drive Tractors-Radar and Bracket Installation

NOTE: Monitor console installation procedure is the same as 30-60 Series Row Crop Tractors.

1. Remove front two cap screws from left-hand side of tractor.

AG,OUO1074,856 -19-01MAR00-1/5

2. Attach radar unit to mounting plate with 1/4 x 4 in. cap screws, washers and lock nuts (do not overtighten). Be certain radar unit is mounted on plate so serial number plate (A) is facing up when plate is attached to tractor.

A-Serial Number Plate

AG,OUO1074,856 -19-01MAR00-2/5

3. Attach mounting plate to tractor with one cap screw (removed in Step 1) and 5/8 in. cap screw and bushing.

AG,OUO1074,856 -19-01MAR00-3/5

4. Route cable back toward rear axle and connect to power module radar lead.

5. Fasten radar cable leads to tractor with tie straps.

AG,OUO1074,856 -19-01MAR00-4/5

CAUTION: Avoid looking directly into the sensor face to prevent possible eye damage from the microwave signal emitted from radar sensor.

6. Loop and tie excess radar cable to tractor beneath SOUND-GARD ® body with tie strap.

SOUND-GARD is a trademark of Deere & Company.

AG,OUO1074,856 -19-01MAR00-5/5