60-70 Series Four-Wheel Drive Tractors-Console Installation

1. Install bracket to inside of cab (Right-hand front near window) using two M10 x 25 cap screws (A).

2. Attach monitor to bracket making certain to install rubber washer on top of strap at mounting.

A-Cap Screws

AG,OUO1074,857 -19-01MAR00-1/5

NOTE: Early 60 Series 4WD have 2-pin convenience outlet Order (AA37254) to convert to 3-pin convenience outlet.

3. Connect monitor (A) to 3-pin convenience outlet.

A-Monitor

AG,OUO1074,857 -19-01MAR00-2/5

4. Install two grommets into plate (A), making certain plate openings are DOWN.

5. Attach plate (A) to tractor cab with six 5/16 x 7/8 in. screws (B).

A-Plate
B-Screws

AG,OUO1074,857 -19-01MAR00-3/5

6. Route harness under cab. DO NOT let excess harness hang loose.

7. Connect extension harness to harness from cab. Fasten connectors under right-hand rear corner of cab with nylon ties as required.

AG,OUO1074,857 -19-01MAR00-4/5

8. Install harness connector mounting spade (A) into socket bracket (B).

9. Route extension harness down center of rear axle assembly toward rear wall of cab. Fasten harness with nylon ties as required.

A-Mounting Spade
B-Bracket

AG,OUO1074,857 -19-01MAR00-5/5