Modification and Installation of Radar Bracket (60 Series Four-Wheel Drive Tractors)

NOTE: The radar bracket needs a 17.5 mm (11/16 in.) hole added to allow bracket to bolt to the frame under the engine.

1. Mark center point as illustrated at (A) and drill 17.5 mm (11/16 in.) hole.

A-Center Point

AG,OUO1074,858 -19-01MAR00-1/2

NOTE: Shift bracket so top of bracket is LEVEL.

2. Install bracket on tractor with two 5/8 x 2-1/2 in. cap screws, flat washers and nuts at (A) using the holes as illustrated.

CAUTION: Avoid looking directly into the sensor face of radar to prevent possible eye damage from microwave signal emitted from radar sensor.

3. Install radar unit on bracket, with serial number plate facing up with cap screws, washers and nuts (B).

A-Bracket Mounting Point
B-Cap Screws, Washers and Nuts

AG,OUO1074,858 -19-01MAR00-2/2