Modification and Installation of Radar Bracket (70 Series Four-Wheel Drive Tractors)

1. Mark center point from (A) and (B) as illustrated and drill 17.5 mm (11/16 in.) hole (C) in radar bracket.

NOTE: Shift bracket until top is LEVEL.

2. Install bracket on tractor with two 5/8 x 1-1/2 in. bolts, lock washers and nuts (D) using holes as illustrated.

A-Dimension, 98 mm (3-7/8 in.)
B-Dimension, 45 mm (1-3/4 in.)
C-Hole, 17.5 mm (11/16 in.)
D-Bolts, Lock Washers, and Nuts

AG,OUO1074,859 -19-01MAR00-1/2

CAUTION: Avoid looking directly into the sensor face of radar to prevent possible eye damage from microwave signal emitted from radar sensor.

NOTE: Be certain radar unit is mounted on bracket with radar serial number plate (C) facing up.

3. Install radar unit (A) on inside of bracket with four 1/4 x 4 in. cap screws (B). (washers under head of cap screws against radar unit), and nuts.

A-Radar Unit
B-Cap Screws
C-Serial Number Plate

AG,OUO1074,859 -19-01MAR00-2/2