OMA59083: COMPUTER TRAK® 150 Monitors 150010001 250 Monitors 250010001, Block File: AG_OUO1074_866_19

1. Remove two plastic plugs on right-hand side of tractor ahead of fuel tank.

AG,OUO1074,866 -19-01MAR00-1/9

2. Install radar bracket with two M20 x 35 cap screws (A).

A-Cap Screws

AG,OUO1074,866 -19-01MAR00-2/9

IMPORTANT: Radar serial number plate must be facing up when radar is installed.

3. Install radar on bracket with four 1/4 x 4 in. cap screws and lock nuts.

4. Remove right side engine cover.

AG,OUO1074,866 -19-01MAR00-3/9

5. Remove six cap screws and washers (A) from exhaust shield. Save for reuse.

A-Cap Screws and Washers

AG,OUO1074,866 -19-01MAR00-4/9

6. Remove exhaust shield (A).

A-Shield

AG,OUO1074,866 -19-01MAR00-5/9

7. Locate 3-pin connector (A) behind exhaust shield.

A-3-Pin Connector

AG,OUO1074,866 -19-01MAR00-6/9

8. Connect radar harness to adapter harness and adapter harness (A) to 3-pin connector.

A-Adapter Harness

AG,OUO1074,866 -19-01MAR00-7/9

9. Coil excess harness and tie away from exhaust using plastic ties as required.

AG,OUO1074,866 -19-01MAR00-8/9

10. Install exhaust heat shield with six cap screws and washers (A) and right side engine cover.

A-Cap Screws and Washers

AG,OUO1074,866 -19-01MAR00-9/9