9000 and 9000T Series Tractor-Radar and Bracket Installation

NOTE: Earlier brackets will need to be modified to avoid interference with hydraulic oil filter housing mounts. After modifying bracket, procedure to install earlier and later brackets is the same.

1. Refer to the illustration and cut a notch out of the top of the bracket at specified dimensions.

AG,OUO1074,868 -19-01MAR00-1/3

NOTE: Shift bracket until top is level.

2. Install bracket on tractor, by hydraulic oil filter housing, using two 5/8 x 1-1/2 in. cap screws (A), flat washers, lock washers and nuts as illustrated.

A-Cap Screws

AG,OUO1074,868 -19-01MAR00-2/3

CAUTION: Avoid looking directly into the sensor face of radar to prevent possible eye damage from microwave signal emitted from radar.

NOTE: Be certain radar unit is mounted on bracket with serial number plate facing upward.

3. Install radar unit on inside of bracket using four 1/4 x 4 in. cap screws (A), flat washers and lock nuts (flat washers under head of cap screw against radar unit).

4. Route harness along right-hand frame to rear of cab. Tie band as required.

5. Connect radar harness to monitor harness.

A-Cap Screw

AG,OUO1074,868 -19-01MAR00-3/3