Install Radar Signal Adapter Harness-7000 Series Tractors Produced After January 1993

NOTE: This harness is used when existing tractor radar will supply signal to monitor and to tractor instrumentation. If tractor is not equipped with radar and a planter radar will be installed, go to "Install Radar".

1. Pull back foam strip and find tractor connector behind right-hand console wrap around.

OM61890,100B -19-28OCT97-1/2

2. Pull connector out from behind console. Connect adapter harness to this 2 pin plug.

3. Position connector near the floor and tuck excess in between console and upholstery.

4. Connect adapter harness to 2-pin plug and to monitor radar connector.

OM61890,100B -19-28OCT97-2/2