Although the tanks are made of a highly durable and corrosion resistant plastic, proper maintenance is required.

Rinse the tank with water when changing from one solution to another.

Rinse tank thoroughly with water after each season or before any shutdown lasting over one week.

Do not allow sludge to accumulate in the bottom of the tank.

Do not leave fertilizer in the tanks if the temperature is expected to drop below 40 degrees as some types of liquid fertilizers will begin to crystallize at this temperature.

To clean the tanks, proceed as follows:

A54938,AH -19-11MAY95-1/3

Remove lids from tanks.

A54938,AH -19-11MAY95-2/3

(Squeeze Pump) Loosen clamp and remove cap (A) from metering pump.

Open shutoff valve going to pumps.

After cleaning tanks, close shutoff valve, replace cap on metering pump or install hose on elbow and replace lids on tanks.

A54938,AH -19-11MAY95-3/3