Rephasing Hydraulic System (6-RW and 8-RN)

To rephase your planter wheel system, proceed as follows:

Lower the planter on level ground and remove clamps and collars (A) from front of master cylinder rod.

TESTOM1,70C -19-08MAY98-1/3

Fully raise planter and hold the remote cylinder operating lever rearward approximately five seconds. The stop on the front of master cylinder rod should come in contact with the cylinder end cap. If the stop is in contact with the end cap, lower the planter and replace the collars and clamp. If the stop is not in contact with the end cap, bleed sufficient oil from the wheel module cylinders to achieve contact. To bleed the wheel module cylinders, proceed as follows:

TESTOM1,70C -19-08MAY98-2/3

With planter in raised position and tractor selector control valve in neutral, install bleeder hose (B) on bleeder valve. Bleed trapped air from each wheel module cylinder (alternating sides of planter) allowing planter to lower and oil to flow until it is free of air foam. Repeat as required.

Fully raise and lower the planter and replace collars.

TESTOM1,70C -19-08MAY98-3/3