Heavy-Duty Closing Wheels

In hard to penetrate soils or seed beds with considerable residue, it may be difficult to completely close the seed furrow with the regular closing wheels. Heavy-duty closing wheels are made of heavy cast material and have an aggressive edge to more effectively close the seed furrow in more severe soil conditions.

NOTE: The heavy-duty closing wheels are not recommended for conventional planting conditions.

Adjustable spring force permits proper closing of the seed trench by firming soil on each side of the seed, not directly over the seed. The closing wheel down force can be adjusted by placing the handle in slots (C), (D), (E) or (F) for varying soil conditions. Placing the handle in the middle slot (G) will allow the closing wheels (A) to FLOAT with only the weight of the closing wheel system on the soil surface. Closing wheel down force increases as the handle is moved rearward.

If closing wheels are not centered over the seed trench or furrow, proceed as follows:

Raise the planter.

Loosen cap screws (B) and adjust closing wheels to the right or left. Visually center as required.

Tighten cap screws (B).

See your John Deere dealer's copy of the Predelivery Instructions for assembly instructions.

A-Closing Wheel
B-Cap Screw
C-Slot C (Minimum)
D-Slot D
E-Slot E (Maximum)
F-Slot F
G-Slot G (Float)

OM62304,100A -19-01MAY98-1/1