Frame Adjustments-1720

Adjust the drive gauge wheels so the unit parallel arms are level or the front is slightly higher than the rear.

A54960,U -19-08MAY98-1/3

The frame may be pinned rigid for planting. After unfolding, install pin (A) between the wings and main frame. The pins and top-fold link will keep the frame rigid.

If pins are difficult to install or remove, proceed as follows:

Raise the planter and release all pressure from the fold cylinders by turning off the tractor and cycle the SCV lever controlling the fold.

A-Pin

A54960,U -19-08MAY98-2/3

Adjust the large nuts (B) on top control link until the locking pins are free.

Tighten nut to maintain the setting.

NOTE: When frame is rigid, all wheels must drive.

B-Large Nuts

A54960,U -19-08MAY98-3/3