Leveling

Integral Planters

1. Drive tractor and planter onto level ground.

OM62502,65B -19-08MAY98-1/2

2. Adjust drive-gauge wheels (A) until planter frame is at shown specifications above the ground.

Specification

When planting, the top of hopper support (B) should be parallel to the ground.

Adjust drive-gauge wheels as follows:

Loosen nut (C).

Turn adjusting bolt (D) clockwise to raise wheel and lower planter frame.

Turn adjusting bolt counterclockwise to lower wheel and raise planter frame.

Tighten nut (C) against casting (E) to prevent bolt (D) from rotating.

A-Drive Gauge Wheels
B-Top of Hopper Support
C-Nut
D-Adjusting Bolt
E-Casting

OM62502,65B -19-08MAY98-2/2