|
Down-pressure does not function.
|
Lock-up valve closed.
|
Open lock-up valve.
|
|
Pressure gauge shows zero when openers are down.
|
SCV lever in float position.
|
Put SCV lever in neutral position.
|
|
|
SCV lever not held forward long enough to charge down pressure system.
|
When lowering openers, hold SCV lever forward long enough for down pressure system to reach pre-set pressure as shown on pressure gauge.
|
|
Openers do not maintain proper ground contact.
|
SCV lever not held forward long enough to charge down pressure system.
|
When lowering openers, hold SCV lever forward long enough for down pressure system to reach pre-set pressure as shown on pressure gauge.
|
|
|
Slow internal hydraulic leakage. (Normal with all hydraulic systems.)
|
Hold SCV lever forward long enough for down pressure system to reach pre-set pressure as shown on pressure gauge.
|
|
|
More hydraulic pressure required.
|
Increase pre-set hydraulic pressure.
|
|
Pre-set pressure does not lower when turning valve knob counterclockwise.
|
Open center attachment traps oil in system until openers are raised.
|
Raise and lower openers to reset to lower pressure.
|
|
|
Pressure valve sticks.
|
Disassemble valve and clean.
|
|
Pre-set pressure does not rise when turning valve knob clockwise.
|
No pressure to adjusting valve.
|
Hold SCV No. 1 in forward position for a few seconds.
|
|
|
Hose couplers not connected properly to tractor.
|
Ensure that hose couplers are connected to proper SCV and locked.
|