Repairing Gauge Wheel Assembly

1. Clean dirt from parts prior to removal.

OUO6023,0000187 -19-08DEC00-1/2

A-Cap Screw, 5/8 x 3 in.
B-Cap Screw and Lock Nuts, 5/16 x 5/8 in.

C-Wheel Half
D-Bearing

E-Rubber Tire

F-Shim Washers (As Required)

2. Remove center cap screw (A) and wheel assembly from arm.

3. Remove hardware (B) to disassemble wheel.

4. Inspect parts for wear or damage and replace as necessary.

5. Replace bearing (D).

6. Assemble bearing (D), wheel halves (C), and tire (E) with seven 5/16 x 5/8 in. cap screws and lock nuts (B). Tighten four outer cap screws first; then three inner cap screws.

7. Attach wheel to arm with shim washers (F) and 5/8 x 3 in. cap screw. Tighten cap screw to specification.

Specification

8. Check clearance between gauge wheel and disk opener. See CHECKING GAUGE WHEEL CLEARANCE-ALL GAUGE WHEELS in this section.

OUO6023,0000187 -19-08DEC00-2/2