Checking Wheel Bolts and Bearings

Tighten all wheel bolts (A) and wheel bearings during the first week of operation and periodically after that.

Tighten wheel bolts to specification.

Specification

To adjust wheel bearing proceed as follows:

1. Remove center hub cap and cotter pin.

2. Tighten nut until there is a slight drag on the bearings, while turning wheel.

3. Back nut off until cotter pin can be installed in hole.

4. Replace hub cap.

A-Wheel Bolts

OUO6076,0000066 -19-08DEC00-1/1