|
Before operating, make sure you have:
[ ] Correctly attached hydraulic hoses to tractor, tillage or cart. Be sure fan motor case drain hose is connected to low pressure (under 689 kPa [6.89 bar] [100 psi]) return port and not crimped.
[ ] Removed obstructions from meter inlet openings inside the tank before filling.
[ ] Closed and locked tank lids to prevent air loss.
[ ] Returned and locked auger in storage position. Returned selector valve to FAN setting.
[ ] Adjusted fan speed for desired application rate. Cleaned fan screen. Adjusted damper position, if double-shooting.
[ ] Inflated tires to proper pressure.
[ ] Checked that meter drive sprockets agree with tire size (at main drive clutch) and row spacing (at one-way clutch).
|
[ ] Thoroughly cleaned product residue from meter segment flutes.
[ ] Customized meter cartridge assemblies by installing/removing product doors, changing out meter segments to agree with product and installing fine tuning rings to agree with secondary manifold ports.
[ ] Checked position of half-width disconnects.
[ ] Checked and, if necessary, reset monitor/controller system with latest information. Checked operation of remote tillage/implement switch.
[ ] Performed rate check and adjusted transmission output speed(s) accordingly.
[ ] Positioned slide on stationary double-shoot manifold in proper position. Ensured handle is trapped between latch pin and bracket.
|