|
IMPORTANT:
For best results, always enter factual data as collected from the seeding tool and cart.
After all entries are made, a meter calibration should be performed to ensure that product delivery meets desired results.
Except for operator entered data, monitor configuration for non-standard seeding tools is no different than configuring monitor for standard applications.
As an example, when row spacing is something other than one that is commonly used for air seeding 15, 19, 25, 30.5,38 cm (6.0, 7.5, 10, 12, 15 in.), enter the actual non-standard row spacing when called for.
Row spacings from 0.1 to 99.9 can be entered.
When a row spacing is entered, standard or non-standard, the system recommends one of the four row spacing sprockets available. This recommendation is based on the entered row spacing and the largest row spacing on the cart, and appears in Air Cart Set-Up screens. The recommended sprocket is the
|
one the system most closely associates with the entered data, and may or may not agree with the actual sprocket on the cart. The system compares the row spacing of the cart to the row spacing entry, starting with the smallest value. If the cart's row spacing is less than or equal to the row spacing entry, the corresponding sprocket is recommended.
When configuring monitor for non-standard application:
1.
Follow set-up instructions, entering non-standard, factual data as needed.
2.
Perform a meter calibration as usual to obtain system generated recommendations, based on custom, non-standard entries.
3.
Manual Transmission: Adjust transmission to agree with recommendation.
Variable Rate: System will automatically adjust transmission setting when seeding starts. Variable rate controller compares the target rate (from prescription menu) with the calculated rate and adjusts the transmission accordingly.
|