Install Radar-8000 Series Tractors

1. Remove two plastic plugs on right-hand side of tractor, ahead of fuel tank.

2. Install radar bracket with two M20 x 35 cap screws (A).

IMPORTANT: Radar serial number plate must be facing up (as illustrated) when radar is installed.

3. Install radar on bracket with four 1/4 x 4 in. cap screws and lock nuts.

4. Remove right-hand side engine cover.

A-Cap Screws, M20 x 35 (2 Used)

AG,OUO6023,993 -19-21JUL00-1/7

5.

Remove six cap screws and washers (A) from exhaust shield. Save for re-use.

A-Cap Screws and Washers (6 Used)

AG,OUO6023,993 -19-21JUL00-2/7

6. Remove exhaust shield (A).

A-Exhaust Shield

AG,OUO6023,993 -19-21JUL00-3/7

7. Locate 3-pin connector (A) behind exhaust shield.

A-3-Pin Connector

AG,OUO6023,993 -19-21JUL00-4/7

8. Connect radar harness to adapter harness and adapter harness (A) to 3-pin connector.

A-Adapter Harness

AG,OUO6023,993 -19-21JUL00-5/7

9. Coil excess harness and tie away from exhaust using plastic ties as required.

AG,OUO6023,993 -19-21JUL00-6/7

10. Install exhaust heat shield with six cap screws and washers (A) and right-hand side engine cover.

A-Cap Screws and Washers (6 Used)

AG,OUO6023,993 -19-21JUL00-7/7