Tractor Requirements

Horsepower Requirements
Machine Configuration 85-95 95-105 105-115 115-130 130-150 150-175 175-200
6 Row 76 cm (30 in.) X X X X X    
6 Row 76 cm (30 in.) with ballast     X X X X  
8 Row 76 cm (30 in.)   X X X X X  
8 Row 76 cm (30 in.) with ballast       X X X X
6 Row 76 cm (30 in.)/11 Row 38 cm (15 in.)       X X X X
6 Row 76 cm (30 in.)/11 Row 38 cm (15 in.) with ballast         X X X
8 Row 76 cm (30 in.)/15 Row 38 cm (15 in.)         X X X
8 Row 76 cm (30 in.)/15 Row 38 cm (15 in.) with ballast           X X
6 Row 70 cm X X X X X    

 

NOTE: Tractors with additional horsepower may be required when operating with additional machine attachments or when planting in soft seedbeds and rolling ground.

Tractor must have approximately 2.8L (3/4 gal.) of hydraulic oil to operate machine.

Tractor hydraulic standby pressure must be a minimum of 15,514 kPa (155 bar) (2250 psi) when used with a vacuum meter installed on machine.

NOTE: A vacuum pump PTO-driven hydraulic system can be used on tractors with open center hydraulics.

Open center hydraulic systems are not compatible with vacuum meter. The vacuum meter pump hydraulic system is designed to be operated with closed center tractor hydraulic systems (tractors with load sensing or pressure on demand hydraulics are classified as closed center systems).

Tractor must have a 12-volt electrical system, a 90-ampere alternator and a 7-pin electrical connector for machine operation.

AG,OUO6074,1166 -19-04AUG00-1/1