30-50 Series Four-Wheel Drive Tractors—Radar and Bracket Installation

A29092
A29092-UN-14OCT88

NOTE: Monitor console installation procedure is the same as 30—60 Series Row Crop Tractors.

  1. Remove front two cap screws from left-hand side of tractor.

  2. A29093
    A29093-UN-14OCT88

    A - Serial Number Plate

    Attach radar unit to mounting plate with 1/4 x 4 in. cap screws, washers and lock nuts (do not overtighten). Be certain radar unit is mounted on plate so serial number plate (A) is facing up when plate is attached to tractor.


  3. A29094
    A29094-UN-14OCT88

    Attach mounting plate to tractor with one cap screw (removed in Step 1) and 5/8 in. cap screw and bushing.


  4. A29095
    A29095-UN-14OCT88

    A29096
    A29096-UN-28JUN89

    Route cable back toward rear axle and connect to power module radar lead.


  5. Fasten radar cable leads to tractor with tie straps.

  6. CAUTION: Avoid looking directly into the sensor face to prevent possible eye damage from the microwave signal emitted from radar sensor.

    A29097
    A29097-UN-14OCT88

    Loop and tie excess radar cable to tractor beneath SOUND-GARD™ body with tie strap.


SOUND-GARD is a trademark of Deere & Company.

AG,OUO1074,856-19-20000301