Install Radar Signal Adapter Harness—7000 Series Tractors Produced After January 1993

NOTE: This harness is used when existing tractor radar will supply signal to monitor and to tractor instrumentation. If tractor is not equipped with radar and a planter radar will be installed, go to “Install Radar”.

  1. H45407
    H45407-UN-25NOV92

    Pull back foam strip and find tractor connector behind right-hand console wrap around.


  2. H45408
    H45408-UN-25NOV92

    Pull connector out from behind console. Connect adapter harness to this 2 pin plug.


  3. Position connector near the floor and tuck excess in between console and upholstery.

  4. Connect adapter harness to 2-pin plug and to monitor radar connector.

OM61890,100B-19-19971028