Keep Service Area Clean

CAUTION: To help prevent personal injury, keep the service area clean and dry. Wet or oily floors are slippery. Wet spots can be dangerous when working with electrical equipment.

Be sure all electrical outlets and tools are properly grounded.

Use adequate light for the job at hand.

Never lubricate or service machine while it is moving. Keep hands, feet and clothing from power-driven parts. Disengage all power and operate controls to relieve pressure.

Securely support any machine elements that must be raised for service work.

Understand service procedure before doing work.

Keep all parts in good condition and properly installed. Fix damage immediately. Replace worn or broken parts. Remove any buildup of grease, oil or debris.

Disconnect wiring harness at 7-pin connector and communication cable from tractor plug before making adjustments on electrical systems or welding on machine.

When welding near an electronic component, such as a monitor controller, unplug all connectors and remove controller from machine to prevent damage to the microprocessors inside.

High voltage electricity from welder can be conducted through the drawbar and damage electronic devices on attached machines. To protect controllers on attached equipment, disconnect equipment from drawbars and hitches before welding.

OUO6023,00016F7 -19-18MAR03-1/1