Priming and Initial Start Up of Pump
IMPORTANT:
Pump crankcase should be equipped with a vent plug. If pump has been removed from machine, remove solid plug in pump crankcase and replace with vent plug to avoid damaging pump.
NOTE:
To facilitate priming of pump, start at maximum rate.
1.
Open shutoff valve at tank and strainer.
2.
Partially fill tank with water and check system for leaks.
3.
Lower machine to planting position and drive 90 m to 180 m (100 yd to 200 yd).
4.
Remove strainer screen and check for foreign material. Clean if necessary.
5.
Select rate of fertilizer using rate charts.
|