Raising and Lowering Markers Connected to Lift Circuit-12/16 Row

NOTE: If machine is equipped with drawbar hitch, the drawbar hitch control switch must be in the MARK position for markers to operate.

NOTE: If the AUTO-MAN switch is in the neutral position (middle), the markers will not operate.

AUTOMATIC ALTERNATION:

1. Place TRANS-PLANT mode switch in PLANT position.

2. Place AUTO-MAN marker mode switch in AUTO position.

3. Activate frame lift SCV. The frame must be completely raised to activate marker alternating switch.

NOTE: Green light in the MARKERS switch indicates which marker will lower in Auto mode.

4. Activate frame lower SCV. Opposite marker will automatically lower.

MANUAL ALTERNATION:

NOTE: The MARKERS switch has two lights in it. The indicator light shows which marker will function.

1. Place TRANS-PLANT mode switch in PLANT position.

2. Place AUTO-MAN marker mode switch in MAN position.

3. Place MARKERS switch in L position to control left marker or R position to control right marker.

4. Activate frame SCV to raise and lower designated marker. Markers will not automatically alternate in this mode. Right and left marker must be manually selected.

LIFTING OVER A FIELD OBSTRUCTION:

A53535

OUO6435,0001F44 -19-26JAN06-1/2

1. Place TRANS-PLANT mode switch in TRANS position. This allows the marker to raise and frame to remain in plant position.

2. Place AUTO-MAN marker mode switch in MAN position.

NOTE: This will shut CCS fan off until marker is lowered and SCV is returned to forward detent position.

3. Pull back on frame SCV to raise marker and avoid obstruction.

4. Select marker with MARKERS R (right) or L (left) switch.

5. Push frame SCV forward to lower marker and activate CCS fan again.

6. Return AUTO-MAN marker mode switch to desired selection.

7. Return TRANS-PLANT mode switch to PLANT position.

LOWERING BOTH MARKERS:

1. Place TRANS-PLANT mode switch in PLANT position.

2. Place AUTO-MAN marker mode switch in MAN position.

3. Select a marker with MARKERS R (right) or L (left) switch.

4. Lower marker.

5. Select other marker with MARKERS R (right) or L (left) switch.

6. Lower other marker.

7. Place AUTO-MAN marker mode switch to desired selection. Both markers will retract when SCV is activated to raise markers.

OUO6435,0001F44 -19-26JAN06-2/2