Specifications

    The seed drill system is connected to the following sensors, switches, and actuators:

  • 2 hopper reserve gauges (1 gauge for 3 and 4 m drills).
  • 1 fan drive shaft sensor.
  • 1 tramline control switch.
  • 1 drive wheel sensor.
  • 2 meter shaft sensors.
  • 2 solenoid shutoff valves.
  • 1 full-width shutoff device.
  • 1 half-width shutoff device.

    The system requires the following to operate correctly:

  • 12 volt power supply (no display below 10.5 volt.)
  • 16 amp fuse.
  • Temperature range: minus 10° C to plus 60° C (14-140° F).

Input data remains stored until canceled.

IMPORTANT: A specified forward speed is required for the display to function correctly.

Specification

Forward Speed (Minimum) -Speed 3 km/h (1.9 mph)

NS43404,0000075 -19-16OCT08-1/1