Configure Frame, Split Row, and Drive Disconnect Warning

1. Select Menu >> Planter button >> Configuration softkey >> Frame tab.

2. Select Rows input box. Enter total number of rows on machine.

3. Select Row Spacing input box. Enter distance between each row unit.

4. Planter Width is automatically calculated. To calculate width manually, select input box and enter a value.

5. Cycle power.

6. Select Clutch Disconnect Warning check box to enable or disable the partial width alarm. When enabled, a full page warning displays for 5 seconds whenever a clutch or drive section is disengaged. A message is displayed on Message Center softkey and monitor beeps every 15 seconds as a reminder.

NOTE: When split row option is chosen, the number of rows, row spacing, and machine width are automatically calculated for monitoring purposes. Split row settings are displayed to the right of input boxes.

7. If machine is a split row design, select Split Row check box. Split Row must always remain checked if planter is a split row design. To toggle between wide and narrow rows when planting, perform the following:

8. Select Rates softkey.

9. If planter is a split row machine, select Rows Planting check box to change between split rows and all rows.

10. Cycle power to ensure all new settings are updated.

Screen Area Information

Planter Configuration Planter Configuration Frame Frame Total Total Rows Rows
A59551

Planter Button

A59172

Configuration Softkey

A59173

Rates Softkey

OUO6074,0000F80 -19-23JUL08-1/2

Row Spacing Row Spacing Planter Width Planter Width Split Row Split Row Split Split Clutch Disconnect Warning Clutch Disconnect Warning Rows Planting Number of Rows Planting

OUO6074,0000F80 -19-23JUL08-2/2