Ground Driven Machines-Target Population and High/Low Warnings

IMPORTANT: Population and High/Low warnings are entered differently for variable rate drive machines. See VRD MACHINES-CONFIGURE METER, CROP, DISK, AND RATES in this section.

NOTE: Number of rows planting are only visible if monitor is configured for a split row machine. See CONFIGURE FRAME, SPLIT ROW, AND DRIVE DISCONNECT WARNING in SETUP Basic Planter Configuration section.

1. Select Menu >> Planter button >> Rates softkey.

2. Select corn, soybeans, or one of the custom crop names. Select Enter button.

3. Select Target Rate input box and enter value.

4. High and low warning limits are automatically set to a percentage above and below the target rate. To change limits, select High and Low Warning input boxes and enter new value.

NOTE: Rates and warning setpoints are saved for each crop name.

Screen Area Information

Planter Rates Planter Rates Crop Name Crop Name Corn Corn Soybeans Soybeans Custom Custom Edit Edit Target Rate Target Rate High Warning High Warning Low Warning Low Warning Population Adjust Population Adjust Rows Planting Rows Planting Avg. Spacing Average Spacing Seeds Seeds ac Acre ha Hectare
A59551

Planter Button

A59173

Rates Softkey

OUO6074,0000F81 -19-23JUL08-1/1