|
Before operation:
IMPORTANT:
Fan motor must be shut off by moving SCV lever to "Float" position. Moving SCV lever into "Neutral" detent can cause fan motor damage.
[ ] Correctly attach hydraulic hoses to tractor, tillage, or cart. Verify fan motor case drain hose is connected to low pressure (under 172 kPa [1.72 bar] [25 psi]) return port and not crimped.
[ ] Remove obstructions from meter inlet openings inside tank before filling.
[ ] Close and lock tank lids to prevent air loss.
[ ] Return and lock auger in storage position. Return selector valve to "Fan" setting.
[ ] Turn off fill lights.
[ ] Adjust fan speed for desired application rate. Clean fan screen. Adjust damper position, if double-shooting.
|
[ ] Inflate tires to proper pressure.
[ ] Check meter drive sprockets agree with tire size (at main drive clutch) and row spacing (at one-way clutch).
[ ] Thoroughly clean product residue from meter segment flutes.
[ ] Check position of half-width disconnects.
[ ] Check and, if necessary, reset monitor and controller system with latest information. Check operation of remote tillage and implement switch.
[ ] Perform rate check and adjust transmission output speeds accordingly.
[ ] Position slide on stationary double-shoot manifold in proper position. Ensure handle is trapped between latch pin and bracket.
|