7000 Series Tractors—Console Installation

1. 
   H45411-UN-02DEC92

   A - L-bracket

   B - M10 x 20 mm Cap Screw (2 used)

   C - Flat Washer

   D - Strap

   E - Wing Nut

   Install L-bracket (A) on front-right corner post with one M10 x 20 mm cap screw (B) in top hole of bracket as shown.

---




2. Install second M10 x 20 cap screw (B) with flat washer (C) in lower slotted hole of bracket.

3. Install monitor strap (D) with M10 x 30 mm carriage bolt and wing nut (E).

4. Attach monitor to strap with rubber washer between monitor and bracket.

5. 
   A35962-UN-17JUL93

   A - Monitor Harness

   Route monitor harness (A) through rear window grommet as illustrated.

---




6. NOTE: Connect harness to rear outlet if tractor is not equipped with front outlet.

   
   H45433-UN-07DEC92

   A - Front Outlet

   (Tractors With Front Convenience Outlet Only) Install monitor into front outlet (A).

---




7. 
   H45416-UN-02DEC92

   A - Monitor Harness

   B - Mounting Spade

   C - Self-tapping Screw (4 used)

   Attach monitor harness (A) to mounting spade (B) using self-tapping screws (C).

---




8. 
   H45417-UN-02DEC92

   A - 7-Pin Connector

   B - Spade Socket

   C - Carriage Bolt

   D - Bracket

   Remove two cap screws securing 7-pin connector (A). Discard hardware.

---




9. Install spade socket (B) with carriage bolt and nut (C). Do not tighten until all hardware is in place.

10. If a planter control box is used, add a second socket to opposite side of bracket (D).

11. 
    H45418-UN-02DEC92

    A - Cap Screws

    B - Spade Socket

    C - Spacers

    D - 7-Pin Connector

    E - Flat Washers

    F - Nuts

    Install cap screws (A) in top hole of spade socket (B).

---




12. Install spacers (C), 7-pin connector (D), flat washers (E), and nuts (F).

13. Tighten all hardware securely.

14. 
    H45419-UN-02DEC92

    Install spade into spade socket and push down to seat.

---