Install Radar Signal Adapter Harness—7000 Series Tractors Produced After January 1993

NOTE: This harness is used when existing tractor radar supplies signal to monitor and to tractor instrumentation. If tractor is not equipped with radar and planter radar is installed, go to “Install Radar”.

  1. H45407
    H45407-UN-25NOV92

    Pull back foam strip and locate 2-pin connector behind right-hand console wrap around.


  2. H45408
    H45408-UN-25NOV92

    Pull connector out from behind console. Connect adapter harness to this 2-pin connector.


  3. Position connector near the floor and tuck excess in between console and upholstery.

  4. Connect adapter harness to 2-pin plug and to monitor radar connector.

OUO6045,00000E4-19-20090206