Raise and Lower Markers with Independent SCV

NOTE: If the AUTO-MAN switch is in the "Neutral" (middle) position, the markers do not operate.

MANUAL WINGLET OPERATION-24 Row Only:

NOTE: Winglet must be folded out before any marker operation.

1. Place TRANS-PLANT mode switch in "Plant" position.

2. Place WINGLET switch in "L" position to control left winglet or "R" position to control right winglet.

3. Activate marker SCV to raise and lower designated winglet.

NOTE: Marker automatically raises when raising designated winglet.

AUTOMATIC ALTERNATION:

1. Place TRANS-PLANT mode switch in "Plant" position.

2. Place AUTO-MAN marker mode switch in "Auto" position.

3. Activate the marker lift SCV and frame lift SCV. The frame must be fully raised to activate marker alternating switch.

NOTE: Green light in the MARKERS switch indicates which marker is activated in Auto mode.

4. Activate SCV to lower frame. Activate SCV to lower marker. Opposite marker will automatically lower.

MANUAL ALTERNATION:

NOTE: The MARKERS switch has two lights in it. The indicator light shows which marker is activated.

1. Place TRANS-PLANT mode switch in "Plant" position.

2. Place AUTO-MAN marker mode switch in "Man" position.

A54101

12 and 16 Row

A54101

24 Row

OUO6435,0001ED4 -19-22MAY09-1/2

3. Place MARKERS switch in "L" position to control left marker or "R" position to control right marker.

4. Activate marker SCV to raise and lower designated marker. Markers will not automatically alternate in this mode. Right and left marker must be selected manually.

LIFT OVER A FIELD OBSTRUCTION:

1. Place TRANS-PLANT mode switch in "Plant" position.

2. Place AUTO-MAN marker mode switch in "Man" position.

3. Activate marker SCV to raise marker and avoid obstruction.

4. Select marker with MARKERS switch "R" (right) or "L" (left) .

5. Activate marker SCV to lower again.

6. Return AUTO-MAN marker mode switch to desired selection.

LOWER BOTH MARKERS:

1. Place TRANS-PLANT mode switch in "Plant" position.

2. Place AUTO-MAN marker mode switch in "Man" position.

3. Select a marker with MARKERS switch "R" (right) or "L" (left) .

4. Lower marker.

5. Select other marker with MARKERS switch "R" (right) or "L" (left) .

6. Lower other marker.

7. Place AUTO-MAN marker mode switch to desired selection. Both markers raise when SCV is activated to raise markers.

OUO6435,0001ED4 -19-22MAY09-2/2