Configure Frame, Split Row, and Drive Disconnect Warning

1. 
   A59325-UN-19FEB07

   Menu

   
   A59551-UN-08MAR07

   Planter Button

   
   A59172-UN-29JAN07

   Configuration Softkey

   
   A59173-UN-29JAN07

   Rates Softkey

   Select Menu >> Planter button >> Configuration softkey >> Frame tab.

---




2. NOTE: If number of rows is changed, RowCommand™ will need to be enabled again.

   Select Rows input box. Enter total number of rows on machine.

3. Select Row Spacing input box. Enter distance between each row unit.

4. Planter Width is automatically calculated. To calculate width manually, select input box and enter a value.

5. Select Clutch Disconnect Warning check box to enable or disable the partial width alarm. When enabled, a full page warning displays for 5 seconds whenever a clutch or drive section is disengaged. A message is displayed on Message Center softkey and monitor beeps every 15 seconds as a reminder.

6. NOTE: When split row option is chosen, the number of rows, row spacing, and machine width are automatically calculated for monitoring purposes. Split row settings are displayed to the right of input boxes.

   If machine is a split row design, select Split Row check box. Split Row must always remain checked if planter is a split row design. To toggle between wide and narrow rows when planting, perform the following:

7. Select Rates softkey.

8. If planter is a split row machine, select Rows Planting check box to change between split rows and all rows.

9. Cycle power to ensure all new settings are updated.

Screen Area Information

Planter Configuration - Planter Configuration
Frame - Frame
Total - Total
Rows - Rows
Row Spacing - Row Spacing
Planter Width - Planter Width
Split Row - Split Row
Clutch Disconnect Warning - Clutch Disconnect Warning
Transport Mode - Transport Mode