Align Countershaft Wing Coupler

A35089
A35089-UN-16OCT92

A - Couplers

B - Flat Surfaces

C - Flat Washers

D - Bolts

E - Shafts

It can be necessary to align couplers (A). Flat surfaces (B) on sides of the couplers must be touching and in alignment. To align couplers:

  • To adjust laterally, add or remove flat washers (C) until flat surfaces (B) are in alignment.
  • To adjust contact of flat surfaces, loosen bolts (D) and align shafts (E).
  • After maximum alignment is obtained on flat surfaces (B) and shafts are in alignment, tighten bolts (D).

DT31797,0000311-19-20090506